This specification covers AFC Cable Systems Liquid-Tuff™ liquidtight Ultraflex™ (1) Recognized component extra flexible non-metallic mechanical protection tubing. (1) Liquid-Tuff™ liquidtight Ultraflex™ recognized component extra flexible non-metallic mechanical protection tubing is designed for use in connection with the support of and protection of insulated wires, placed within the tubing, that are used to interconnect separate component assemblies or consoles of electrical apparatus, such as x-ray equipment. Use of the combination is to be determined by underwriters laboratories Liquid-Tuff™ liquidtight Ultraflex™ extra-flexible non-metallic tubing is designed for use in wet, dry or oily locations as a flame resistant, non-metallic raceway for power, control and communications cables. The product is intended for use at 60 deg C (140 deg F) in a dry location, 60 deg C (140 deg F) in a wet location and 60 deg C (140 deg F) in a oily location. It is sunlight resistant.

AFC Cable Systems Ultraflex™ Liquid-Tuff™ Liquidtight Non-Metallic Tubing, Type NMPT-B Corrugated, Series: 160, 2 in, 2.02/2.045 in Inside Dia, 2.352/2.363 in Outside Dia, 100 ft Coil Length, 1.59 in Bend Radius, Extra Flexible Flexibility, 60 deg C, PVC, Black

• Specification Sheet https://www.iesbuy.com//ASSETS/DOCUMENTS/ITEMS/EN/AFC_Cable_Systems_160_012_Datasheet.pdf
• Specification Sheet https://www.iesbuy.com//ASSETS/DOCUMENTS/ITEMS/EN/IDW_DOCUMENT_1520618258825.pdf

• This tubing may be used for the routing of internal wiring between electrical components of electrical equipment
• The protection afforded to the internal wiring by the tubing may be considered equivalent to the protection afforded the internal conductors by the jacket of a type SJT flexible cord
• The tubing and manufacturer's supplied fittings were not tested to determine flammability rating per UL 224
• The tubing shall be terminated at each end of the consoles or appliances to which connected to provide strain relief to withstand a 35 lb pull for 1 min
• The percent fill of the tubing with conductors shall not exceed 75% where percent fill is defined as percent fill, area of enclosed conductors x 100/internal area of tubing fill factor
• The minimum bend radius shall not be less than the outside diameter of the tubing
• The manufacturer's fittings were subjected to the oil spray test in accordance with UL 514B
• Final acceptance will be determined in terms of the combination of component and appliance as determined by Underwriters Laboratories Inc. regarding such characteristics as flammability, degree of bending or flexing, resistance to water, oil and abrasion and physical strength